markfields Posted October 24, 2006 Share Posted October 24, 2006 Is the Moab Entrada 300 weight (the heavier paper) too thcik for the back feeder special attahcment on the epson 2400? I sometime use Hahnemuhle 308 Photo Rag on the 2400 on the back attahcment but the Moab is very slightly thicker... si this a problem? Thanks Mark Link to comment Share on other sites More sharing options...
KenPapai Posted October 24, 2006 Share Posted October 24, 2006 Usually I feed the Entrada thru the normal single sheet feeder, on top, where you can stack several sheets at once. It sually takes a little coaxing from my hands to get the heavy Moab fed properly into the R2400. I've never had good luck with the rear single sheet only feeder. I've never seen this demo'd properly anyway so I always resort to the top multisheet feeder, but one at a time for the thick papers. Link to comment Share on other sites More sharing options...
john_brewton Posted October 25, 2006 Share Posted October 25, 2006 I always use the back feeder. I have never had any problems. It must be done correctly, however. See your owner's manual. Link to comment Share on other sites More sharing options...
guillaume_zuili6 Posted October 25, 2006 Share Posted October 25, 2006 I had constant problem with this paper, the issue is the dust that paper has, it goes into the rollers and after a while you have an error message from the printer. You need to clean the paper at first and use the single front loader. Best. Link to comment Share on other sites More sharing options...
biggerjon Posted December 11, 2006 Share Posted December 11, 2006 I have had a similar issue with Hahnemuhle 308 Photo Rag which i am loading from the front. What setting should be selected in the printer driver? I am using a variety all with the same results namely - smudges across the leading and RH edge as you look at it. Any ideas? Is there a profile i can download for this paper? Thanks Jon Link to comment Share on other sites More sharing options...
tmaxphoto Posted March 21, 2007 Share Posted March 21, 2007 I have been feeding Innova F-Type gloss, 300 gms, through the top (normal) feeder without any problems so long as I place single sheets in. Peter Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now