labce__
-
Posts
17 -
Joined
-
Last visited
Never
Content Type
Profiles
Forums
Blogs
Events
Downloads
Gallery
Store
Posts posted by labce__
-
-
I`ll second the Goo Gone method.When I first got my cameras they were
really grungy.I first used a rubber pencil eraser to get off the crud
stuck in the shutter speed and focus dials.(You`ll chew up a few
erasers doing this.)The eraser also took off the heavy dirt on the
back plate.Next I used Goo Gone on the entire aluminum case.It cleans
nice and the camera smells really nice,too!The Goo Gone also took the
white residue off the inside black area where the film cassette
goes.I used a little dabbed on a Q-tip.You`ll be surprised when you
swirl the Q-tip around the round areas where the film cartridge fits-
it`ll come out black!
-
I`ve recently used ASA 12 film in my Minox B camera and since there`s no setting for ASA 12,I estimated the distance one stop past ASA 25 and set the camera there.At that time I noticed the direction of rotation of the ASA setting wheel.If you are using ASA 100 film,you would set the ASA at 100 and the shutter speed at 1/100 to synchronize the camera;if you then move the ASA wheel one stop over to ASA 200,the shutter speed on the camera moves to 1/50.Shouldn`t the shutter speed move to 1/200,a faster speed?Isn`t this backwards?
-
I`m wondering if infrared film records heat,like police helicopters
with forward-looking infrared that shows glowing image of heat source
(hidden person,car engine,etc.)and would show up on negative as
glowing heat source?
A ghost hunter/author I met uses infrared film to record images
of "ghosts" or "spirits" at haunted places.Anybody heard of this?
-
I`ve seen infrared film offered in Minox cartdidges and heard of Minoxers slitting 35mm infrared film into Minox format.What is infrared film used for?What do the results look like?
-
I have been shooting black & white ASA 400 (grainy in enlargements)and ASA 100 (better but a little grainy in enlargements).I have just ordered a slitter and would like to try slower films.Can ASA 50 or ASA 25 black & white films be used in a Minox IIIs or B hand-held?Will film this slow work indoors without flash?I`d like to shoot 80% outdoors/20% indoors with no flash and get at least 5 x 7 prints.If these speeds will work,can anyone recommend a good film brand and type?Thanks.
-
David-
The Minox IIIs doesn`t have three filters,it has two.The earlier
ones have green and orange filters and the later ones have the green
and neutral density(black) like the B models.
My first Minox was a IIIs and I guestimated the shutter speeds with
no problems.You don`t need a light meter with the IIIs if you have
basic photographic knowledge,or if you don`t mind experimenting with
a few rolls of film.(I surprised myself with how close I guessed the
settings!)
I also have a B now,and the light meter is nice,but the IIIs IS the
classic Minox.(Best to conceal,too-I`m a private invesytigator.)
-Lance Novak
-
Martin-
The 8mm movie film frame is from edge to edge of the film.(No
borders.)The sprocket holes are obstructing the top or bottom of your
frame,depending on how you load the film.(I keep the holes on the
bottom of the frame so while shooting I can keep in mind I`m losing
the very bottom of negative area.)I used ASA 100 and 400.It works,but
I just ordered a slitter and plan to slit 35mm film in the future.I
don`t want to try Pathe 9.5,since it`ll probably jam the camera.With
8mm,you have to enlarge to almost 8 x 10 to get a 5 x 7 print-you
lose lots of negative area.(To slit is better!)
Question: How is ASA 25 or ASA 50 film for Minox?Are they too slow to
hand-hold?Is quality(less grain) better than ASA 100?I noticed much
better quality with ASA 100 film than with ASA 400 film in
enlargements.
-
I tried asking MPL to return the empty cassettes on Minocolor I sent
in to have processed.No dice-they didn`t even acknowledge my request
to say they couldn`t return them.
-
I have been having excellent results with Acufine developer at 1:1 on
both Minox factory B&W film and also reloaded Kodak Super 8mm B&W
movie film.
-
I have a thermometer with my old 50-exposure Minox tank,but never use
it since I`m worried about breaking it in the tank.Also,it doesn`t go
down far enough when developing smaller rolls of film.I made a wooden
dowel the same diameter as the thermometer and about 8 inches long
and it works fine.
-
I use the Minox tank for developing and fixing,then unwind the film
into a larger 35mm tank for rinsing.I place it in the sink with
running water flowing through the tank for an hour(probably too long)
and it comes out perfect.
-
I just recently saw a great World War II submarine movie for the
zillionth time.It`s called "Up Periscope".The whole point of the
story is for the sub to get James Garner close to a Japanese island
so he can swim ashore and photograph a codebook with a Minox Riga.He
uses the camera properly,but no measuring chain!I guess he`s a really
a good judge of distance!The camera even sounds right.Check it out.
-
I finally tried the Kodak Super 8mm B&W movie film in a Minox B
camera.I reloaded a Minopan 36-exposure cartridge with the
recommended length for a 50-exposure roll.(This actually gives about
53-54 exposures.)The cartridge took 50 exposures fine.The film went
through the camera with no problems.When loading into the Minox
developing tank(mine takes 50-exposure rolls)I had to make a hole in
the end of the film(I used a stationary store hole-puncher)to engage
the screw on the drum.(The metal clip isn`t strong enough to pull the
tightly-wound 50 exposures out of the cartridge.)The film developed
nicely and printed fine on a Minox enlarger.You just have to keep in
mind whether the film sprocket holes will be on top or bottom of your
negatives when you`re shooting pictures.It worked great and was a LOT
cheaper than buying a splitter!
-
To B or not to B,that is the question;whether it is nobler to use an
A and suffer the over- and under-exposures......
-
I was e-mailed asking where to get 8mm movie film for Minox
respooling.You have to get Super 8mm film-regular 8mm film is
actually 16mm wide!It`s shot on one side,flipped,then shot on the
other side.It`s split into 8mm during processing at the lab.The Suoer
8mm film I bought is Kodak B&W Reversal film.It comes in Tri-X(ASA
400)and Plus-X(ASA 100)and comes in a cartridge(light trap!)and you
pull it out as needed.
I got mine(along with rolls of Minopan 100 and 400 in 36 exposures
for $7 a roll)for about $11 for 50 feet from Samy`s Camera-(800)321-
4726.I learned that they had a local store in Hollywood near me,so I
went.Huge discount photography warehouse-darkroom stuff,etc.The local
professional photographers rave about their prices.They have a Minox
department(probably with great prices on new & used Minoxes)but it
closes at 7 p.m.PST and I was there later(store closes at 8 p.m.PST.)
so I don`t know what else they have.
I previously ordered Super 8mm and several rolls of Minopan(at $5 a
roll)from Cambridge Photo in New York,but after weeks of them lying
and saying that the order "went out today",I finally got somebody who
told me they still had it on backorder and had NOTHING in stock!(I
cancelled.)They were also very rude and obnoxious to deal with on the
phone.
I also ordered Super 8mm film from Adorama in New York and Sy was
very helpful.They sent me color by mistake(I ordered Tri-X B&W)and I
returned it but have yet to see the Tri-X.
Hope this helps.
-
Has anyone tried respooling super 8mm movie film into Minox
cassettes?I used to respool b&w 16mm movie film into Minolta
cassettes when I was into Minolta 16mm cameras years ago.I have just
gotten into Minox cameras and have just bought a cartridge of super
8mm tri-x (ASA 400) b&w film.Haven`t tried it yet,but the 8mm width
is pretty close to Minox film and no splitter is required!The
sprocket holes will be annoying,but if you shoot your frames a little
larger than you want,it won`t matter.
Developing large rolls of Minox film
in Minox/Miniature
Posted