Jump to content

Film Holders


michael_kadillak3

Recommended Posts

Was interested in purchasing some additional 5x7 and 4x5 film holders and seem to remember reading that Fidelity and Lisco were manufactured by the same company. The original holders I purchased were Fidelity and they seemed to work fine. Is there any reason that I should be concerned about purchasing some Lisco holders? Thanks.
Link to comment
Share on other sites

Michael: I read your post and compared the Lisco and Fidlity holders

side by side. To my surprise, the are both marked as being made in

Sun Valley, Calif. and carry the same U.S. patent number. The only

difference is a different pattern around the film chamber. Otherwise,

they are identical to the smallest measurement. I have several of

both and have been well satisfied with both. One problem to watch for

with plastic holders...the bar across the top where the slide goes in

can warp enough to prevent the holder from seating tightly against

the camera back. I have three that are unuasable because of this

fault.

 

<p>

 

Regards,

Link to comment
Share on other sites

I love the older Riteways (not to be confused with the new ones which

are expensive and i have heard nothing but bad things about).I get

them at camera shows for about 7 to 8 dollars apiece. the tape on the

bottom is much better than the new fidelities and the finger thats

holds the darkslide actually works.before you buy them just check

that the tape is not to worn and that the holder is pretty clean.

Before I use them I check them for leaks and i usually vaccum them

out and clean them with alcohol.-J

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...