l_w_mcleroy

<p>I purchased NX 1.1 and NX 2 from ImageMixer. When recently moving to a new computer, Nikon said the NX 1.1 key was not valid. I emailed ImageMixer and they provided a new key which works for me.</p>

<p>I'm a little like the gentleman above who believes in getting it right in the camera. However, there is always a little that can be done and there is almost always some improvement with sharpening. For those things, I like Picture Project (but organize mostly with directory structure) and Capture NX since they work well together. I love the control points in Capture NX and I can do the most common adjustments in less than a minute. If I need to do something complex, I do everything I can do easily in NX and save a TIFF or JPEG. Then I do the final, complex editing in PS7. </p>

Bernhardt,

 

Thanks for that suggestion. That's the problem I had before that I couldn't remember. My Sigma has a lock for the f stop ring but I don't remember the Nikkor having that. In fact, I don't think it has an f stop ring. When using manual or A priority, I use the camera control panel to set f stop. I say I can't remember it having an f-stop ring because with it in the repair shop I can't look at it. I took it to a camera shop and they put a DX lens on my camera and it focused fine. then they put my lens on another Nikon and no focus. I guess everything breaks eventually but I have now had the Sigma and the Nikkor fail in less that 2 years after purchase.

Thanks for your replies. I tried the contact cleaning with no change. I guess I'll be visiting a camera store today.

I'm no pro, which will quickly be obvious, so this question may be related to defective

equipment or a defective operator (i.e. incorrect settings).

 

Suddenly, my Nikkor 18-135 lens will not focus. There is no motor sound when

pressing the shutter and normally the shutter will not fire. When it does, it is out of

focus. I can switch to manual focus and that works fine. The lens switch (A-M) is in

the A position. The switch on the camera body (C-S-M) is in S but the C position gives

the same result. When I remove the Nikkor and install a Sigma DL Hyperzoom 28-300

it does focus. I have been using all of the equipment mentioned above for mostly travel

photography for over a year. I had one other time that an incorrect setting caused a

problem similar to this buy I can't remember the exact facts and I've tried everything I

can think off including reading the troubleshooting section of the manual. Since the

lenses in question have different electrical characteristics, 8 contacts on the Nikkor and

5 on the Sigma, I know I cannot rule out a problem in the camera body. My questions

are:

 

1) Is it possible that this is an operator error and, it so, what settings can I check?

 

2) Is it an equipment defect, and if so, which piece or how can I tell which piece is

defective?

 

I know we have a lot of very advanced photographers here and I thank you for your

time and any help you can offer.