nikon dcs 420

[edersandro_lopes]

Hi !

I bought this used nikon dcs 420 .I have all the

cables,charger ,the camera is working fine ,but i am not been able

to get the computer to find the camera !!!!

I tought i needed a camera drive but Kodak told me this camera

has no drive .Can anyone help me to figure out what softawre do i

need? All i need is the cd or floppy that came with this camera,

but this is an old camera and it is hard to find.

Can anyone help me???

[frank_skomial]

I have no idea what dsc 420 is, but I believe it came with a software for a Windows version that accepts USB (not Windows NT or older)?, and most likely you are connecting via USB port?

You need to Uninstall the software that was installed for this camera, and re install again. Ask any kid how to do it. Reboot the computer after the Uninstall is done. Make sure that when you install the software, the camera is not connected to the computer YET. After software installation you will need to reboot the computer again, and then plug the camera to the USB port. Basically these are steps that should have been written up in a Quick installation guide, or any documentation for the software. If this does not work, you may need to do hardware setup manually in Windows XP, or W2000, in whatever Windows 98 you have. Story too long to cover here.

[mike_elek]

Go to Kodak's Web site and enter "dcs 420" in the search field. You should be able to find a link to the camera, and from there you should be able to download some of the software you might need.