Flashing iso 3200 in P mode on my EPL-1, how do I change iso?

[mark_stephan2]

<p>I have a flashing ISO 3200 in Program mode on my Olympus EPL-1. How do I change the iso to iso 200?</p>

[Greg M]

<p>You change the ISO in Program mode like you would in any of the advanced modes. Assuming your camera is currently in auto ISO, the most obvious way to change it is to open the super control panel and manually change it from auto to whatever setting you want to use. You could have also assigned the ability to change the ISO to another button on the back, but I am assuming you have not done that if you are not sure how to change the ISO at all.</p>

<p>I'm also assuming above you have activated the super control panel. That may or may not be a good assumption. It sounds like you need to pull out the manual and/or go to a site like the link below that has extensively reviewed the E-PL1 body and all the body options...<br>

<a href="http://www.dpreview.com/reviews/olympusepl1/">http://www.dpreview.com/reviews/olympusepl1/</a></p>

 

[r.t. dowling]

<p>On my E-PL1, I'm able to change the ISO by pressing the round "START / OK" button on the back of the camera. This brings up a variety of different settings and options. Press the up or down buttons until you get to ISO, then press the left or right buttons to select your desired ISO, then press the START / OK button to save your changes.</p>

<p>Reading the manual is always a very good idea, of course. ;-)</p>