rob_garsson Posted September 13, 2011 Share Posted September 13, 2011 <p>My YN RF-602 stopped working recently. Both the controller and receiver have power and are lighting up, they are on the same channel, but the controller will not trigger the receiver! I tried three different receivers out and none of them are catching the signal. They've always worked perfect for until now so it's kind of a bummer hopefully someone here knows of some kind of fix. Thanks =0</p> Link to comment Share on other sites More sharing options...
Mattman944 Posted September 13, 2011 Share Posted September 13, 2011 <p>Have you tried replacing the battery in the transmitter. The light may flash even if the battery is too low for the transmitter to work properly. </p> <p>You might want to consider buying a spare or two while they are still available. I have several spares.</p> Link to comment Share on other sites More sharing options...
george_ghio Posted September 13, 2011 Share Posted September 13, 2011 <p>Depending on your camera/lens combination the trigger may not work at shutter speeds above 200. Set the shutter speed to 100 and try again.<br> Oh yeah, and the bloody batteries. Always have a spare set or two.</p> Link to comment Share on other sites More sharing options...
rob_garsson Posted September 14, 2011 Author Share Posted September 14, 2011 <p>Thanks for the replies.<br> Must have been the battery. Took it out of the trigger for a few minutes and then put it back in and now it works, although I suspect not for long. I figured because the light was still blinking on the trigger that the battery was fine but it seems that is not the case. Off to go buy some batteries I guess!</p> Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now