evgeny1 Posted December 23, 2007 Share Posted December 23, 2007 Hi, Two days ago: I unlocked top section in my stand and it failed down approx 10-15" causing strike to my Hensel Integra 500W. Then the flash worked 10 minutes as usual. After 10 minutes its modeling bulb fired and I found the need to replace the bulb. I had no time to replace the bulb during photo session, so I inserted a new bulb of same type after the shooting ended. Yesterday I shoot a model. Unfortunately the modeling light in the flash did not work. The flash switches to Full and Proportional modes using buttons on the control panel and via radio device, but the modeling bulb doesn't light. Should I replace a fuse of modeling bulb and where is it located? What else can I check and do? Thanks! Evgeny Link to comment Share on other sites More sharing options...
randy_kurtz Posted December 23, 2007 Share Posted December 23, 2007 Is the PROP switch lite up in green? If so maybe change the bulb out agen... Link to comment Share on other sites More sharing options...
evgeny1 Posted January 2, 2008 Author Share Posted January 2, 2008 The PROP switches, the bulb replaced. It was the fuse connected to the bulb. Replaced the fuse, too, the modeling light works. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now