Jump to content

Three general questions.


Recommended Posts

I have two general questions I hope folks here may have suggestions on.

 

<p>

 

1. Cleaning film

I just got a new scanner (a Nikon LS-4000) and in playing with it last night, I was a little too vigorous in cleaning a 6-frame strip of transparency film. Small scratches appeared in the scan. They were not visible when I put the strip on the light table and looked at it through a loupe but surprisingly, I could see them when I held the strip at a shallow angle and viewed it directly. Fortunately, the Digital ICE product is very impressive in removing scratches. I had put some Edwal film cleaning fluid on a piece of micro-fiber cleaning cloth, then pulled the strip through the folded cloth. Squeezing too hard put the scratches on the film.

 

<p>

 

"Well, don't squeeze so hard!", I hear you say. Probably the answer but does anyone have other film cleaning tips?

 

<p>

 

 

2. M6 bags.

I have a small Tamrac bag I use to carry my M6 but it just has a flap that closes over the top of the case, rather than a zip that would keep dirt out. Or, as I discovered on vacation in Australia last month, a zip that'd keep sand out! I want to carry a spare roll of film, a spare battery and a small notepad. What are folks using? I've browsed several shops and not found quite what I want.

 

<p>

 

Suggestions would be much appreciated on both of these. Also, if anyone has questions about the new Nikon scanner, I'd be happy to answer them (or send you a sample scan).

 

<p>

 

Regards,

Fergus

Link to comment
Share on other sites

On the film scratches: I just use an anti-static brush and/or

compressed air to remove dust. Removing dust should not require liquid

film cleaner or the scratch-prone wiping. That tactic should be

reserved for when you have something really nasty to remove, and even

then with the understanding that you may damage the acetate and/or

emulsion in the process. For me, it's a "last resort".

 

<p>

 

On the bag: I use a very small Billingham that has the protection

you're looking for, but less of the bulk and boxiness typical of

most Billingham models. I want to say the "f/5.6 model", but I'm not

sure about that. I'll check the Billingham site and confirm or

correct.

Link to comment
Share on other sites

I just checked www.billingham.com. The bag I refer to above is the

"Series 3" model. Great protection with less than the typical

Billingham bulk. Downsides are...

 

<p>

 

1) Not cheap. B&H lists for just under $200 USD. But then neither is a

CLA cheap, for your precious Leica et al.

 

<p>

 

2) In the process of tightening the bag up to keep sand and prying

fingers out, the bag can be a little slow for you to access. The bag

does have the provision for folding back the top zippered flaps, and I

don't find this a really objectionable problem.

Link to comment
Share on other sites

For almost 40 years I've been wiping the dust off of my film with the

same tool--my fingers. I'm blessed with hands which aren't

particularly oily, neither wet nor dry, and not corrosive either (in

my current field that can become painfully obvious), which I guess is

a matter of personal body chemistry. Anyway, To make a scratch an

object must be harder than the film, and I guess my fingers aren't,

whereas objects trapped in soft cloth sometimes are. I just squeege

the film between my first two fingers immediately before working with

it. Static is never a problem this way, either. I've had a number of

anti-static and film wiping products through the years, and none has

ever matched my fingers. It's probably not for everyone, but you

might want to give it a try. I never touch the surface with my

fingerprints, however.

Link to comment
Share on other sites

Bag: Domke F5XB "Belt and Shoulder Bag". Same size as Billingham

Series 3, with additional belt tunnel so it can be worn as a

waistpack, shoulder bag--or both for greatest comfort and security.

Under $50 at B&H. Can be customized to hold up to 2 M bodies and 4

lenses plus flash and filters. Comes in Tan, Navy or Black canvas,

looks much less like a woman's handbag than the Series 3.

Link to comment
Share on other sites

I too use the fingers and canned air. Every once and a while, if I

have a neg with water stains, the can be removed with a light

wiping with a CLEAN microfibre cloth, but I cringe everytime I've

done it. For bags I love the new MClassics Leica bag which is a

direct copy of the old Leitz canvas bag from the 60's. It wraps

right around your hip, holds a body, three lenses, accesories,

and has enough room for a notebook or such.

Link to comment
Share on other sites

Just comments about bags, I use a Billingham Photot Hadley, the size

is OK for a body plus 2 extra lenses, or 2 bodies with 1 lens on

each. It doesn't come with any fancy feature, but it looks good for

city tours, can protect the camera from heavy rain or snow, no wife

factor here(not ugly). For general purpose I think Domke is an all-

around bag.

Link to comment
Share on other sites

Since you want to carry so little grear, take a look at the LowPro

Camera Pocket or Porta Pocket belt pouches. They are so easy to

carry (wear) and will hold an M6 + 50mm (or wider) lens with plenty

of room for film, paper, and battery. I got one for my SLR, but then

my M6 took it over. Perfect for street shooting (dare I say perfect?)

Link to comment
Share on other sites

Fergus, are you using the Tamrac Superlight 5? I have one. It will

hold an M6 with 50mm lens, plus four more lenses, and a second M body

with no lens. Plus assorted lenshoods, filters, & film.

Unfortunately, it's no longer Superlight when thus burdened, though

that's not the bag's fault. As you say, the main compartment

doesn't zip, so it's less than optimal. Also a bit large.

 

<p>

 

This brings us to the Lowepro Nova 1. This bag zips, has a generous

front zip pocket and slim rear zip pockets as well, and mesh side

pockets. It holds one M6 with 50mm and up to four (if smallish) or 2

or three larger leica M lenses, with enough room, again, for hoods &

other accessories. I took it on a trip with an M6, 50mm Summicron,

35 Lux, 28 2.8 Elmarit, 21mm Superangulon & finder, & 90mm Elmarit.

It all fit, and this is a very small bag! Tenba has something

similar but pricier & a bit roomier. But the Lowepro is a bargain!

 

<p>

 

Film cleaning: I brush with a 1" staticmaster. Canned air

sometimes. I never wipe, never use liquids, & never scratch film.

Vaccuming the darkroom eliminates most need for heroic film cleaning

measures.

Link to comment
Share on other sites

I use my fingers too but only to wet out after photo flo during

developing, afterwards only brushes and special cleaning liquid,

about camera carry bags, it of course depends on what are you

carring, I like to have several diferent sizes, for one camera I

always carry a belt bag like those you can find in any lugage store,

you can always foam it and it doesn´t look as a camera bag, and it

can be apropiate for any situation, they usualy have diferent size

pokets for film or shade, or what so ever adiction.

Link to comment
Share on other sites

I've had a lot of luck with something like your clearning fluid- I

don't what it was- it seemed to be alcohol based (volatile), and I just

used it to swab my negs before printing. I think it was fine even with

CN-400 which tends to be a bit easier to scratch than others.

<p>

As for bags... the right bag seems as elusive as the photo with great

bokeh, composition and the decisive moment. I have a LowePro Nova

Micro,

<p>

<a href="http://www.lowepro.com/pages/bySeries/nova.htm#"> http://

www.lowepro.com/pages/bySeries/nova.htm#</a>

<p>

which will probably fit what you're looking for. It's padded, boxy,

small, with a removable shoulder strap and straps for a waist strap.

Its lid on the top zips closed and also has a clip and strap if you

don't want to zip. I wouldn't call it weather or sandstorm proof, but

the zipper goes over the inside lip, so that it's somewhat sealed. It

has a front zippered pocket where you can put 4-5 rolls of film, and

two side pouches of mesh.

<p>

It's versatile too, if you have other cameras to carry- I've used it

for a TLR, Fuji 645GS, SLR and two small lenses.

<p>

HTH...

Link to comment
Share on other sites

I really like my Domke 803 Satchel! It's relatively small & light,

very discreet and can hold 2 M bodies (w/ lenses attached) and 2

additional lenses mounted back to back (plus plenty of film and

accesories).

 

<p>

 

If that's too big, then the Domke FX5 maybe what you're looking for.

If you like the 803 Satchel, but want even more flexibility, then the

M Classic bag looks pretty good.

Link to comment
Share on other sites

I've got one of the original bags that the "M-Classic" was copied

from, and I've seen and felt the M-Classic when a fellow walked into

my local camera store with one while I was there. It is completely

destructured and has *zero* padding and unless you fasten the

snap/buckle straps each time (mine has 3)there are only the smallest

patches of velcro to keep it closed. You wouldn't want to set the

bag down quickly on anything hard or have it swing and hit a doorjamb

or wall. It's basically like a tote bag, good for film and other

unbreakable items. There's no way I personally would carry thousands

of dollars worth of Leica equipment in it, unless each piece was in

its own padded case, which would defeat the purpose of the bag.

Link to comment
Share on other sites

Jay's right. I forgot to mention it, but I have two of

these "classic" bags. They do have three slip pockets in front and a

roomy interior pocket. Once you put a camera in the interior pocket

and lenses in the slip pockets, That's all the camera gear that

should go in it, because the roomy bag interior has no provision to

keep things from clanking together and getting scarred up or even

damaged. It doesn't carry comfortably, because it's large and the

strap is just unpadded cotton. So why do I have two of them? They

make great ditty bags in the back of the jeep to store flashlight,

rain gear, weather radio, etc. You could even toss a point-and-shoot

in there.

Link to comment
Share on other sites

The Alice is a nice bag, John. You're right, if you want to carry a

couple of M bodies and only a couple of lenses without a zip closure.

The bag is boxier and bulkier than the Series 3, which I use for a

single body and a couple of lenses. The Series 3 has a zip

closure, which the Alice doesn't have, and which is where this thread

all started. I use the Alice, too, but for bulkier SLR camera/lens

that doesn't need protection against wind-blown sand. The nice thing

about the Alice is the faster access top.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...