Jump to content

D70 with Chronic "FOR" Error


karen_breen_bondie

Recommended Posts

About six months ago I started to experience a sportatic "FOR" error with my

D70 camera. Initially, I thought it was the memory card, since I using a

SanDisk 1 GB Ultra II CF card exclusively when it would occur. After the last

time it happened, I switched to my older SanDisk 1GB CF card, and it still

occurred.

 

I surmise that the problem is not my memory cards, but the camera. I haven't

taken it in, nor have I seen any other problems posted concerning this problem

on the web.

 

What happens is that when I'm shooting, usually sports photography in

continuous mode, all of a sudden I can't press down the shutter so I look and

see that there is the "FOR" error. At that point, the card has essentially

rendered all photos that I've just shot until that point as non-viewable until

I use Photo Rescue PC to recover the damaged files.

 

In order to continue shooting, I will turn the camera power off, remove the CF

card and reinsert until the "FOR" error message disappears and then I can

continue shooting. The camera has never been stuck in the "FOR" mode, nor have

I been faced with having to otherwise reformat the memory card.

 

After I recover the files, I must reformat the disk through the camera in

order to rid the card of the corrupt files.

 

I bought the camera new in April of 2004. Any suggestions what might be

causing this and why? I have not updated the firmware. Should I? Anyone

else having/had this problem?

Link to comment
Share on other sites

I'm no repairman. :)

 

But, I would say if you're having write problems with the card interface, you may potentially be having read problems as well. If you have a read problem mid-firmware update....you may have a useless piece of plastic until you get it serviced.

 

I'd send it in for service and see what the cost might be myself. Someone else may have better advice though.

Link to comment
Share on other sites

Sandisk's CF cards are not so good. I never had such problem until I got a 1GB Sandisk CF card lately. Exact same as yours under same continuous shooting mode. "FOR" "ERR" or corrupted files only happen when I use Sandisk's card. My old cheapo PQI never gave a problem. Toss the Sandisk and get some other brand. Nothing to do with firmware.
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...