Nikon Scan 4.0.2 For Mac

Discussion in 'Digital Darkroom' started by davebecker, Mar 9, 2009.

  1. I've been working successfully with this software on my CS 9000 but now have a problem I'm sure you can help me with. When I open the software the only window that opens is "Tool Palette 1". None of the other controls are visible. Any idea why I'm not seeing the Scan Window and other controls?
    I tried a re-install - same problem.
    Thanks for your comments.
    Dave Becker
     
  2. Did you switch on the scanner before starting the software? Wait until the green scanner light stops blinking and is steady on- then start Nikonscan. Hope this helps.
    Peter
     
  3. Peter,
    That seemed to do the trick. I don't recall seeing these specific instructions in the Owners manual. Thanks for your ssistance.
    Regards,
    Dave
     
  4. Peter,
    That seemed to do the trick. I don't recall seeing these specific instructions in the Owners manual. Thanks for your ssistance.
    Regards,
    Dave
     

Share This Page