Can I buff out scratches?

Discussion in 'Minox' started by d__, Feb 9, 2000.

  1. d__

    d__

    My minox B has a few very minor scratches. They are shallow and only visible in light, when you are looking for them. Does anyone know if there is a way to buff them out? Even though they are hardly visible, I know they are there. I am sure u all know what I mean. Any advise would be appreciated!
    Dave
     
  2. Dave, your 'scratches'are almost invisible, leave it alone :)
    <p> Minox surface is anodized aluminium, it is a thin layer of poros aluminium oxide, which renders the surface a matt look.
    I don't think you can buffle oxide like you buffle metal surface, the risk here is that if you do buffle, you certainly can remove all traces of scrathes, but you may end up with big stretches of shinny patches.
    <p> But I know very little about treatment of anodized surfaces, may be other Minoxers have some special methods.
     
  3. No, do NOT try to buffle anodized surfaces!!!!
    This surface is only about .001 mm thick, and if
    you buffle hard, you will just remove it, having
    a very sensitive surface of pure aluminium under it.
    You could dismount the whole camera, take the housing
    to a galvano-workshop and order a new anodized surface.
    But, this is not worth the effort, I think....
     
  4. Aha, Oliver is right<p> If you buffle anodized surface, you take off
    the protection layer.
     

Share This Page

1111