Jump to content

Lens board Beseler 45


chris_autio

Recommended Posts

Luckily, you have the threaded flange. Cutting a suitable hole in a bit of 4" x 4" material shouldn't be too challenging.

 

I've used offcuts of laminate flooring material for lensboards in the past.

 

Unusual to see a Sironar in an illuminated iris mount. Are you sure it's not a Rodagon?

Link to comment
Share on other sites

Nice job.

I am not using Beselers lately, but I did make some boards with a three point alignment axis (screws). Same as yours, but the lens is mounted on a smaller (thinner) floating plate, attached to the 4x4 "plate with three Allen screws. There is a 1/4" neoprene foam material between the two plates for allow such an adjustment while maintaining light tightness. I think it was Delta who was selling boards already made this way (aluminum).

This makes the alignment job much faster and easier than using the system provided by the Beselers.

Edited by jose_angel
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...